6" PVC Sewer & Drain Cap – P1606 WEST S&D 7020 for Secure Termination
Engineered for use in gravity-flow sewer and drainage systems, the P1606 WEST S&D CAP 6" 7020 is designed to seal off 6-inch PVC S&D lines with a reliable, watertight connection. This socket-style cap fits securely onto pipe ends, protecting systems from infiltration, backflow, and contamination during maintenance or long-term closure.
Key Performance Features
✅ Engineered Fit – Designed for socket-type installations on 6" PVC S&D pipe, providing a dependable seal without compromising system integrity.
✅ Durable PVC Construction – Manufactured from high-strength PVC for resistance to corrosion, chemicals, and impact.
✅ Non-Pressure Use – Ideal for gravity drainage applications where long-term durability is critical.
✅ Code Compliance – Designed to meet ASTM D3034 and other applicable standards for S&D fittings.
Typical Applications
The P1606 6" S&D cap is used in non-pressurized drainage systems, commonly in:
✔️ Sewer line terminations
✔️ Cleanout access points
✔️ Temporary or permanent system closures
✔️ Site drainage networks and stormwater systems
Specifications
Nominal Size: 6 inches
Material: PVC (polyvinyl chloride)
Fitting Type: Cap
Connection: Socket (solvent weld)
Standards: Typically manufactured to ASTM D2729 or D3034, where applicable
Installation Guidance
Installation requires a clean pipe end and a compatible solvent cement for a permanent, watertight bond. Ensure the cap is seated fully during assembly. Professional installation is recommended for regulated drainage systems or municipal applications.
Note for Contractors
This cap is suitable only for non-pressurized systems. It is not intended for potable water or pressurized sewer lines. Always verify compatibility with local codes before installation.
The P1606 WEST S&D CAP 6" 7020 is a reliable solution for terminating 6-inch drainage runs. Its rugged construction and code-aligned design make it a staple in commercial and residential sitework.