3/4 inch x 1/2 inch x 3/4 inch Cast Brass Reducing Tee Copper x Female x Copper

3/4 inch x 1/2 inch x 3/4 inch Lead-Free Copper Reducing Tee – For Code-Compliant Transitions

The 3/4 inch x 1/2 inch x 3/4 inch Lead-Free Copper Reducing Tee is engineered to facilitate branch line transitions in potable water and hydronic piping systems. Manufactured from lead-free wrought copper, this tee supports a reduced branch outlet while maintaining consistent flow in the main line. Its design meets ASTM and ANSI dimensional tolerances and is compatible with standard soldering practices.

This reducing tee is commonly used in domestic supply lines and is designed for use in pressure applications. The corrosion-resistant copper alloy ensures long service life in both residential and commercial environments. All sockets are manufactured to accept copper tubing per applicable sizing standards.

Application Benefits

• Code-Compliant Copper Alloy – Lead-free material meets NSF/ANSI 61 and 372 standards for potable water use.
• Wrot Copper Body – Resists dezincification and ensures thermal and mechanical stability during soldering.
• Reduced Branch Connection – Designed for 1/2 inch branch lines off a 3/4 inch main run, supporting balanced distribution.
• Consistent Wall Thickness – Provides uniform heat distribution during installation, minimizing risk of cold joints.
• Pressure-Rated – Suitable for use in systems up to 200 PSI at ambient temperatures when installed properly.

Installation Notes

Install using standard soldering techniques with approved flux and lead-free solder. Ensure that all surfaces are properly cleaned and deburred before joining. Follow applicable local plumbing codes and manufacturer instructions. Suitable for both horizontal and vertical applications. Thread sealant is not required, as this is a solder cup fitting.

Common Applications

This copper reducing tee is typically found in branch line terminations for kitchen, bathroom, and utility water supply systems. It is also used in hydronic heating loops where reduced circuit takeoffs are required.

Technical Specifications

• Material: Lead-Free Wrot Copper
• Nominal Sizes: 3/4 inch x 1/2 inch x 3/4 inch (C x C x C)
• Standards: ASME B16.22, NSF/ANSI 61 and 372 compliant
• Temperature Range: Up to 400°F when soldered with approved methods

This fitting is specified where reduced branch takeoffs are needed in copper plumbing systems and provides a reliable, code-approved solution for potable water distribution.