2 inch x 1-1/2 inch x 1-1/2 inch Copper Reducing Tee Copper x Copper x Copper

2 inch x 1-1/2 inch x 1-1/2 inch Copper Reducing Tee – Wrot Copper, Lead-Free

The 2 inch x 1-1/2 inch x 1-1/2 inch Copper Reducing Tee is a wrot copper fitting used to join copper tubing of different diameters in potable water distribution and hydronic heating systems. It provides a straight run with a reduced branch outlet and is designed for use in soldered systems where dimensional accuracy and long-term mechanical integrity are critical.

This tee is fabricated from lead-free copper in accordance with ASTM B75 or B88 and meets applicable standards for potable water applications. The fitting is sized using nominal copper tube dimensions and includes three female sweat (cup) connections for use with soft or hard-drawn copper tubing.

Performance and Application Features

• ✅ Configuration: C x C x C (2 inch run x 1-1/2 inch run x 1-1/2 inch branch)
• ✅ Material: Wrot copper, lead-free (<0.25% Pb) – compliant with NSF/ANSI 61 and 372
• ✅ Manufacturing Standard: ASME B16.22 – Wrought Copper and Copper Alloy Solder Joint Pressure Fittings
• ✅ Pressure Rating: Up to 200 PSI at 250°F when properly installed with soldered connections
• ✅ Application Scope: Potable water distribution, chilled water, and low-pressure hydronic systems

Installation Guidelines

Install using approved lead-free solder and flux. Clean mating surfaces with emery cloth or fitting brush, apply flux evenly, and heat the joint to allow solder to flow fully around the fitting. Allow joints to cool naturally before pressure testing. Follow applicable IPC/UPC code requirements for joint preparation and testing.

Typical Use Cases

This reducing tee is commonly specified in domestic water distribution systems to branch off to smaller diameter supply lines while maintaining full flow in the main run. It is also used in mechanical systems where zone or fixture-level transitions are required.

Regulatory Compliance

This fitting is certified for use in potable water systems under NSF/ANSI 61 and 372. It complies with the U.S. Safe Drinking Water Act and is suitable for installations in all jurisdictions requiring lead-free components.

Technical Specifications

• Nominal Sizes: 2 inch x 1-1/2 inch x 1-1/2 inch
• Connection Type: Copper Solder Cup x Cup x Cup (C x C x C)
• Material: Wrot Copper, Lead-Free
• Standards: ASME B16.22, ASTM B75/B88, NSF/ANSI 61 & 372

The 2 inch x 1-1/2 inch x 1-1/2 inch Copper Reducing Tee is a code-compliant solution for branching and size transitions in copper tube systems. Its dimensional accuracy and corrosion resistance make it a reliable component for new construction and system retrofits in potable and mechanical piping networks.