1 inch PVC 90 Degree Insert Elbow Insert x Male

1 inch PVC Insert 90 Degree Elbow – Engineered for Secure and Efficient Transitions

The 1 inch PVC Insert 90 Degree Elbow is designed for use in cold water irrigation and sprinkler systems where polyethylene pipe connections require a tight and secure directional change. Its barbed insert end ensures a firm grip inside flexible PE tubing, while the 90-degree angle offers efficient routing around corners without compromising flow.

Key Product Features

• Application: For use with polyethylene pipe in cold water distribution systems such as irrigation, agriculture, and landscaping
• Material: Injection-molded PVC – known for durability, corrosion resistance, and chemical stability
• Connection Type: Insert x Insert (barbed ends for flexible PE pipe)
• Angle: 90 degrees – ideal for sharp directional changes without reducing system integrity
• Pressure Rating: Typically rated up to 100 PSI at 73°F (check manufacturer specs for confirmation)

Installation Guidelines

To install, insert the barbed ends into polyethylene tubing using a twisting motion. Use stainless steel clamps (not included) to secure each joint for optimal leak resistance. Installation is straightforward with no solvent cement required. Ensure pipe ends are cut clean and square for best results.

Typical Use Cases

This 1 inch PVC insert elbow is commonly used in:

• Drip irrigation and turf watering systems
• Agricultural field distribution lines
• Commercial landscape watering installations
• Low-pressure water service connections

Did You Know?

Insert fittings are often preferred in field-installed systems using flexible pipe due to their fast assembly and robust sealing when properly clamped. Their ability to handle rough environmental conditions makes them ideal for outdoor plumbing configurations.

Specification Summary

• Size: 1 inch nominal
• Material: White PVC (polyvinyl chloride)
• Fitting Type: Insert Elbow, 90°
• Compliance: Suitable for cold water systems; not intended for pressurized potable use

Designed for functionality and long-term performance in non-potable cold water systems, the 1 inch PVC Insert 90 Degree Elbow is a trusted choice for contractors looking for quick, reliable directional fittings. Combine with proper clamps and tubing for a professional-grade installation that performs under pressure.