1/4 inch Copper 90 Degree Elbow Copper x Copper

1/4 inch Copper 90° Elbow – Lead-Free, Sweat Connection for Directional Transitions

The 1/4 inch Copper 90-Degree Elbow is a standard fitting used to redirect flow within Type K, L, or M copper tube systems. Designed for soldered connections, this elbow enables a 90-degree change in direction for water distribution, hydronic heating, or HVAC piping applications.

Product Features

• Material: Lead-free copper suitable for potable water applications
• Connection: Sweat (copper x copper)
• Angle: 90 degrees for sharp directional change in tubing layout
• Size: 1/4 inch nominal pipe size
• Certification: Complies with NSF/ANSI 61 and 372 for lead-free plumbing applications

Application & Use

This elbow is designed for use in water supply lines, vent systems, and hydronic circuits. It is appropriate for above-ground installations and is compatible with standard copper tubing for sweat connections using soldering methods. It should not be used in gas distribution systems unless otherwise specified by code and fitting design.

Installation Considerations

Install using proper soldering practices. Surfaces should be cleaned with abrasive cloth and flux applied before assembly. Heat with a torch until solder flows into the joint by capillary action. Allow adequate cooling before pressure testing. Always confirm compatibility with local code requirements before installation.

Performance & Durability

Manufactured to meet ANSI/ASME B16.22 standards, this elbow maintains structural integrity under standard water system pressures. Copper construction offers long-term corrosion resistance and is appropriate for a variety of temperature and pressure conditions in domestic water and mechanical systems.

Typical Applications

• Potable water distribution systems
• HVAC and hydronic heating loops
• Non-potable water systems with compatible materials

Use of this copper elbow helps streamline system design and enables compact layout in tight or concealed locations. It is suitable for new installations, retrofits, and repair work where directional changes in copper tubing are required.