1/2 inch x 6 inch Brass Nipple

1/2" x 6" Brass Pipe Nipple – Threaded Fitting for Pressure-Rated Systems

The 1/2" x 6" Brass Nipple is a straight, male-threaded fitting used to extend or connect sections of pipe in fluid-handling systems. Manufactured from lead-free brass, this component offers mechanical strength and corrosion resistance in potable water and general utility applications.

Machined to NPT specifications, this nipple provides a secure connection for joining compatible brass, copper, or steel components in environments requiring reliability, chemical resistance, and thermal stability.

Key Performance Attributes

• ✅ Lead-Free Brass Composition – Fabricated from certified lead-free alloy suitable for potable water systems and code-regulated applications.
• ✅ Threaded Ends – Male NPT threads on both ends ensure compatibility with standard fittings and pipe segments in 1/2" nominal size.
• ✅ Corrosion Resistance – Brass provides excellent resistance to mineral scaling and oxidation in potable and non-potable systems.
• ✅ Working Pressure Tolerance – Rated for use in water, oil, air, and low-pressure steam systems under typical operating conditions.
• ✅ Dimensional Accuracy – Produced to ensure thread integrity and alignment in close-tolerance assemblies.

Installation Considerations

Apply thread sealant or PTFE tape to all mating threads. Use appropriate wrenches and avoid overtightening to prevent thread deformation. Ensure fittings are properly aligned to prevent stress at the joint. This component is suitable for horizontal and vertical installations where a rigid, pressure-rated connection is required.

Typical Applications

Commonly installed in water supply lines, equipment manifolds, air compressor assemblies, and hydronic heating systems. Its 6" length provides intermediate extension between valves, tees, and other threaded components in confined or offset configurations.

Technical Specifications

• Material: Lead-Free Brass
• Nominal Size: 1/2 inch
• Length: 6 inches
• Connection: Male NPT x Male NPT
• Standards: Complies with NSF/ANSI 61 and federal lead content requirements

Material Insight

Brass is a preferred choice for threaded fittings in potable water and fluid handling due to its antimicrobial properties, resistance to dezincification, and compatibility with copper alloys. Its durability makes it suitable for long-term installations where mechanical stress and temperature variation are expected.

The 1/2" x 6" Brass Nipple provides a secure and corrosion-resistant solution for pipe extension and component transitions in threaded systems. Use where reliability, pressure resistance, and regulatory compliance are required in a compact threaded assembly.