1/2 inch PVC Schedule 40 90 Degree Elbow Plastic x Plastic

Schedule 40 PVC 90° Elbow – 1/2 inch to 4 inch Solvent Weld

The Schedule 40 PVC 90-Degree Elbow is manufactured for use in pressure and non-pressure systems to facilitate directional changes in piping layouts. With its solvent-weld socket ends, this fitting is designed to provide reliable, watertight turns in horizontal or vertical pipe runs. It meets applicable ASTM and NSF standards for use in potable water, irrigation, and drainage systems.

Technical Performance Attributes

• Material: Rigid Polyvinyl Chloride (PVC Type I, Grade 1)
• Size Range: Available from 1/2 inch to 4 inch nominal pipe size (NPS)
• Wall Standard: Schedule 40
• Connection Ends: Socket x Socket (solvent weld)
• Conformance: ASTM D2466 and NSF 61/14 certified for potable water applications

Design and Functional Advantages

• Corrosion Resistant: Will not rust or degrade in high-humidity environments or in contact with aggressive water chemistries
• Hydraulic Efficiency: Smooth interior bore reduces flow resistance and minimizes pressure loss at directional changes
• Non-Conductive: Safe for electrical isolation and chemically inert under typical system conditions
• Lightweight Design: Simplifies transport and handling on-site without compromising mechanical strength
• Thermal Range: Recommended for service temperatures up to 140°F (60°C) at reduced pressures

Installation Requirements

Install using standard PVC solvent cement and primer in accordance with ASTM D2855 guidelines. Joint surfaces must be clean and dry prior to assembly. Cure times will vary by temperature and humidity; pressurization should be delayed until curing is complete. For pressure-rated applications, always confirm compatibility with system pressure requirements and local code enforcement.

Applications

Appropriate for use in a wide range of residential, commercial, and light industrial plumbing systems, including:

• Potable water distribution
• Drain, waste, and vent (DWV) lines
• Irrigation and landscape piping
• Chilled water and HVAC condensate drain routing

Specification Note

This fitting is not intended for use in compressed air or gas distribution systems. Use only with compatible pipe materials and solvent cements rated for PVC Schedule 40 systems.

The Schedule 40 PVC 90° Elbow delivers consistent joint integrity and fluid handling performance where change-of-direction fittings are required. Its compliance with national standards and robust design make it an essential component for plumbing systems demanding long-term dependability.