1/2 inch Black Iron Cap

1/2" Black Iron Cap – Threaded Pipe End Closure for Gas and Mechanical Systems

The 1/2" Black Iron Cap is a threaded fitting used to terminate and seal the end of a pipe in non-potable mechanical and fuel gas piping systems. Designed with internal National Pipe Thread (NPT) connections, it provides a pressure-rated seal for piping assemblies requiring closure during system design, maintenance, or testing.

Manufactured from malleable black iron, this cap is suitable for use in air, steam, gas, and oil systems. It conforms to industry performance standards and is commonly installed in Schedule 40 or Schedule 80 threaded piping configurations in both residential and commercial environments.

Technical Specifications

• Material: Malleable Black Iron
• Nominal Size: 1/2 inch
• Connection Type: Female NPT
• Finish: Black (Oil-Coated)
• Standards: ASTM A197, ASME B16.3
• Pressure Rating: 150 psi steam; 300 psi air/oil/water (non-shock)

Key Features

• ✅ Threaded Closure – Precision-cut female NPT threads allow secure sealing at pipe terminations.
• ✅ Non-Potable System Use – Intended for gas, oil, and air service; not approved for potable water lines.
• ✅ Heavy-Duty Construction – Durable under mechanical stress and high operating temperatures.
• ✅ Corrosion-Resistant Surface – Oil-coated finish offers basic protection during storage and installation.

Installation Guidelines

Apply thread sealant or PTFE tape to male pipe threads before assembly to ensure a pressure-tight seal. Tighten by hand, then finish with a pipe wrench to avoid under- or over-torquing. Inspect for alignment and leaks during pressure testing per system requirements. Follow applicable mechanical and fuel gas codes for installation procedures.

Typical Applications

Commonly used in gas distribution networks, low-pressure steam systems, compressed air loops, and process lines to seal unused outlets, terminate future branches, or isolate test points. Suitable for indoor mechanical rooms, utility risers, and appliance connections.

Code and Compliance Notes

This cap complies with ASME B16.3 dimensional and pressure standards and is typically used in systems designed under NFPA 54 (fuel gas) or IPC/IMC for mechanical service. Not suitable for use in potable water systems due to material limitations.

The 1/2" Black Iron Cap provides a reliable and code-compliant solution for sealing threaded piping terminations in mechanical and fuel gas applications. Its robust construction and compatibility with standard fittings make it an essential component in pressure-rated system closures.