1-1/4 inch PVC Schedule 40 90 Degree Street Elbow Fitting x Plastic

1-1/4 Inch PVC Schedule 40 90° Street Elbow – Spigot x Slip

This 1-1/4 inch Schedule 40 PVC 90-degree street elbow is designed to create a tight directional turn in a non-pressurized drain, waste, or vent (DWV) system. The spigot x slip configuration allows the spigot end to fit directly into the socket (hub) of another fitting, reducing the overall number of components needed and streamlining layout in confined areas.

Product Specifications

• ✅ Material: PVC compound meeting ASTM D1784, cell class 12454
• ✅ Size: 1-1/4 inch nominal pipe size
• ✅ Wall Rating: Schedule 40, per ASTM D2466
• ✅ Ends: Spigot x Slip (Socket)
• ✅ Bend Angle: 90 degrees

Standards and Compliance

• ✅ Meets: ASTM D2466 for dimensional and performance specifications
• ✅ Joining Method: Solvent-weld (primer and cement) using ASTM F656/F493 compliant products
• ✅ Application: Non-pressure DWV systems only

Installation Considerations

Install with proper surface preparation, including cleaning and priming both mating surfaces prior to solvent welding. Maintain alignment to ensure consistent flow and proper venting. Allow sufficient cure time before system pressure or leak testing. Avoid use in systems exceeding temperature and pressure limits for Schedule 40 DWV fittings.

Common Applications

• Branch transitions in horizontal drain lines
• Vent piping in wall cavities and above ceilings
• Offset corrections in tight or framed spaces

Material Performance

Schedule 40 PVC provides resistance to most acids, alkalis, and organic solvents typically found in residential and light commercial wastewater systems. It offers a lightweight and corrosion-resistant alternative to cast iron for DWV installations where building code allows.