1-1/2 inch Copper 45 Degree Press Elbow Copper x Copper

1-1/2” Copper 45° Press Elbow – Press-Connect Fitting for Directional Offsets

The 1-1/2” Copper 45° Press Elbow is a press-connect fitting designed for directional changes in copper tube systems. Engineered for use in potable water, HVAC, and hydronic heating applications, this elbow facilitates smooth angular transitions while maintaining system integrity and flow performance.

Manufactured from lead-free wrought copper, this fitting features factory-installed EPDM sealing elements for permanent mechanical connections without soldering or open flame. Designed for joining ASTM B88 Type K, L, or M hard-drawn copper tubing, it is compatible with most commercially available press tools and jaw sets conforming to manufacturer tolerances.

Performance Features

• ✅ Press-Fit Connection – Enables rapid installation without heat, flux, or soldering equipment, reducing labor time and fire risk.
• ✅ Lead-Free Alloy – Fabricated from copper material conforming to NSF/ANSI 61 and 372 for use in potable water systems.
• ✅ Angled Design – 45-degree bend supports directional flow changes in tight spaces where 90° fittings are impractical.
• ✅ Pressure Rated – Tested for use in systems up to 200 PSI (depending on system temperature and tube specification).
• ✅ Reliable Seal – Includes pre-installed EPDM sealing element designed for water, air, and glycol-based systems.

Technical Specifications

• Fitting Type: 45-Degree Elbow
• Nominal Size: 1-1/2 inch
• Material: Lead-Free Wrought Copper
• Connection: Press x Press (compatible with standard press jaw profiles)
• Sealing Element: EPDM (pre-installed)
• Standards: ASME B16.51, NSF/ANSI 61 & 372, IAPMO, UPC, IPC-compliant

Installation Guidelines

Ensure copper tube ends are cut square, deburred, and cleaned before inserting into the fitting. Mark insertion depth, align the tube properly, and use the correct press tool and jaw size specified by the press system manufacturer. Do not press over existing soldered or crimped joints. Always verify system pressure and temperature compatibility.

Application Scope

This fitting is commonly used in residential, commercial, and institutional installations for water distribution systems, chilled water loops, and closed-loop hydronic systems. Its 45° bend allows for clean routing around structural obstructions and precise directional changes in tight mechanical spaces.

Compliance and Regulatory Note

Meets federal lead-free requirements for potable water distribution and is approved for use in jurisdictions adhering to IPC, UPC, and NSF-listed standards. Always verify local code acceptance before installation.