1-1/2 inch ABS DWV 90 Degree Elbow Plastic x Plastic

1-1/2” ABS DWV 90° Elbow – High-Performance Fitting for Drainage Systems

The 1-1/2” ABS DWV 90° Elbow is manufactured for use in drainage, waste, and vent piping systems where a 90-degree change in direction is required. Constructed from acrylonitrile butadiene styrene (ABS), this elbow provides a robust and efficient solution for DWV configurations in both new construction and renovation settings.

Key Features

• Injection-Molded ABS – Impact-resistant and dimensionally stable, offering durability across a range of installation conditions.
• Code-Compliant – Conforms to ASTM D2661 and CSA B181.1 for use in non-pressurized DWV systems.
• Uniform Wall Thickness – Ensures structural integrity and consistent solvent weld bonding performance.
• Slip Hub Ends – Designed to connect with schedule 40 DWV pipe using solvent cement, providing a secure, permanent fit.

Technical Specifications

• Material: ABS (Acrylonitrile Butadiene Styrene)
• Size: 1-1/2 inch nominal
• Angle: 90 degrees
• Ends: Hub x Hub (Slip-fit)
• Applications: Non-pressure DWV plumbing systems
• Standards: ASTM D2661, NSF 14

Installation Guidance

For best results, pipe ends and fitting hubs should be clean and free of debris prior to solvent welding. A heavy-bodied ABS cement is recommended to ensure a secure bond. Allow sufficient cure time before testing system integrity. Always follow local plumbing codes and manufacturer instructions during installation.

Typical Applications

This fitting is utilized to redirect flow in sanitary drainage systems, often in lateral lines connecting to vertical stacks or fixture drains. It is suitable for above-ground residential and light commercial plumbing systems where a clean and secure directional change is essential.

Note:

ABS fittings are not recommended for use with compressed air or gas. This product is intended for use in gravity-flow drainage applications only.